Label printer cab EOS 1, EOS 4 (archive)

Basic version

For printing on labels and roll materials. The printed material is torn off by the jagged edge.

Stand-alone version print

In addition to the basic version, it has the ability to print autonomously where there is no AC power supply. A powerful 24 V battery is used for power supply. The battery is supplied separately as additional equipment.

Cutter

All printed materials can be cut. The cutter rotates to change the material.

Cutter and perforation cutter

Roll materials such as textile or heat shrink tubing are used perforation cutting to manually separate markers after printing. In addition, materials can be cut off completely. The cutter rotates to change the material.

External Unwinder

The material roll is automatically centered when placed on the unwinder. The unwinder is not compatible with the EOS mobile printer version.

Print roller DR4-25

For materials up to 25 mm wide, with partial rubber coating

Print roller DR4-50

For materials up to 50 mm wide, with partial rubber coating

SD memory card

8 GB

USB flash drive

8 GB

USB WLAN adapter

2.4 GHz 802.11b/g/n

USB WLAN adapter with antenna

2.4 GHz 802.11b/g/n + 5 GHz a/n/ac in infrastructure mode with rod antenna for extended reach

USB Bluetooth adapter

RS232 C Cable

9/9 pin, 3 meters long

Brake for fanfold labels

For printers EOS2 and EOS5. The accordion-folded material is fed smoothly into the printer and printed accurately. The brake is not compatible with the EOS mobile version of the printer.

External battery

For stand-alone printing. The charger is included in the package. The battery is installed at the bottom of the printer. The battery capacity allows for up to 500 prints of 100×68 mm labels and 15% print density.